Measurement, diagnosis and correction — from one team.
We combine our field balancing and predictive maintenance expertise with every supporting condition monitoring technique.
Field Balancing (On-Site Balancing)
Single or two-plane dynamic balancing of rotors in their own bearings, at operating speed, without dismantling.
ISO 21940-11 · single / two-plane
Predictive Maintenance
Periodic condition monitoring programmes that detect failures before they happen, using vibration, temperature and ultrasound data.
ISO 17359 · ISO 20816-3
Vibration Analysis
Root-cause diagnosis of vibration with FFT spectra, time waveforms, envelope and phase analysis.
FFT · envelope · phase
Laser Shaft Alignment
Precision laser shaft alignment for motor-pump, motor-gearbox and all coupled machine trains.
Laser system · soft foot
Infrared Thermography
Hot-spot detection in electrical panels, motors, bearings and mechanical components with infrared thermography.
Infrared imaging · ΔT
Ultrasound Inspection
Ultrasound detection of bearing lubrication condition, compressed air leaks and electrical discharge.
Airborne & structure-borne
Four steps of a site visit
Every job follows the same order; nothing is closed until a measurement confirms the result.
-
Baseline
Horizontal, vertical and axial vibration at each bearing: overall level, spectrum and phase.
-
Diagnosis
We confirm the problem really is unbalance, separating misalignment, looseness, resonance and bearing defects.
-
Correction
Single or two-plane balancing with trial weights and influence coefficients; laser alignment where needed.
-
Report
Before/after values, ISO zone classification, weights applied and recommendations.
Is your machine vibrating? Let's talk before it stops.
Tell us the equipment type, speed and the symptom you observe; we will plan the measurement and site visit together.